A commonly used standard to quantify finished quality of elevated and slabon- ground slabs is the ASTM Standard E The procedure outlines the method of . slab-on-ground slabs is the ASTM Standard, ASTM E The procedure outlines the method of profiling finished concrete to determine the flatness (FF) and. ASTM E Standard Test Method for Determining FF Floor Flatness and FL Floor Levelness Numbers.
|Published (Last):||23 February 2013|
|PDF File Size:||7.42 Mb|
|ePub File Size:||5.77 Mb|
|Price:||Free* [*Free Regsitration Required]|
Use the defaults for this exercise. Repeat for several runs, as shown above.
These notes and footnotes excluding those in tables and figures shall not be considered as requirements adtm this test method.
By now you should have a grasp of the following:. Select all the sample lines. Generate a Report from the Analysis The command will automatically build a standard report.
Lines are created to represent runs with traditional equipment. If you would like to download the file used in this article, download the accompanying Training Data and extract its contents to a folder on your PC.
A simple workflow from importing the files to producing a report of the surface deviation analysis.
Create Lines for Each Run Next we will create a line for each run, the end result will appear as shown: When the traffic patterns across a floor are random, as is generally the case evaluation of the 1e155 F F Flatness and F L Levelness will necessarily involve a random asgm of the surface, since all of the infinite potential profiles to be seen by the traffic can not possibly be measured.
No other units of measurement are included in this standard. A simple w orkflow from importing the files to producing a report of the surface deviation analysis.
Module 6.2: Floor Flatness and Level ASTM E1155 with BuildIT Construction
Construct a polygon line around the area shown below. Historical Version s – view previous versions of standard. Click on the Report tab and click on Generate Report.
Asstm is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
When prompted specify a location and name for the PDF report. Select a start point and then select an end point for the first line. Split cloud Creating lines representing a run.
By now you should have a grasp of the following: Next we will create a line for each run, the end result will appear as shown: A complete metric companion to Test Method E has been developed, Test Method EM ; therefore, no metric equivalents are shown in this test method. Line Panel for each completed line.
Module Floor Flatness and Level ASTM E with BuildIT Construction – FARO® Knowledge Base
Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard. In those instances when the traffic across a floor will be confined to specific paths, however, the requirement for random sampling is eliminated, since the floor can indeed be inspected exactly as it will be seen by all of the traffic.
Split cloud down to the area to be analyzed.
In these special cases, rather than inferring the condition of the traffic paths from a random sample, it is asym more useful to measure each of the traffic paths directly using continuous recording floor profilometer configured to run exactly in the traffic wheel paths.
Link to D1155 This link will always route to the current Active version of the standard. Tutorial Download If you would like to download the file used in this article, download the accompanying Training Data and extract its contents to a folder on your PC.
Such aatm simulation measurements eliminate the inherent uncertainties of statistical sampling and provide profile information immediately applicable to the correction of the surface in way of the future traffic. To avoid errors, save the current project before attempting the Floor Flatness Analysis.